Chase-durer Fighter Command User Manual download pdf (Page 7)

Setting Time Zones/Leap Year

February 28 will normally change to March 1 and only needs to be adjusted on February 29 every four

years to accommodate leap years.

Correcting for Leap Year

1. Pull setting crown out to position and turn the hour hand counterclockwise (backwards) 24 hours

or two revolutions.

3. Screw down the setting crown to finish.

2. Push setting crown back to position and the right LCD (date) will display the correct date

1. Pull setting crown out to position and turn to set the hour hand to another time zone when

traveling, or to adjust for Daylight Savings.

Setting Time Zones

Note - The hour displayed in the left LCD will also

change in synchronization with the hour hand!

If you wish to retain the original time zone,

pull setting crown to position and

press button to set LCD’s to time mode.

Reset the current hour on the left LCD

by pushing button until original time is

displayed.

Please note that the LCD time is used for the

Alarm function! If you wish to have the Alarm

synchronized to the hour hand, then the LCD

and hour hand must be set to the same time.

CHASE-DURER

FIGHTER

COMMAND

ALARM DATE

1/100 SEC330 FEET

9 3

45 15

GENEVE

Set crown in

position 2 to

only the hour hand

adjust

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

No comments

Chase-durer Fighter Command User Manual Page 7